Training Programs

Training Programs offered at LiUNA Local 527, (the top three are mandatory to go out to work)

 

 

4 hours
Workplace Hazardous Materials Information SystemCheck Schedule
8 hours

Legislation, full body harness, guard rails, and all other equipment & safety requirementsCheck Schedule

5 hours
Guidelines for workers performing traffic control, included in CCW Apprenticeship programCheck Schedule
40 hours
Oxy-Acetylene and Oxy-Propane steel cutting, brazing, introduction to arc-welding. Included in CCW Apprenticeship ProgramCheck Schedule
6 hours
Introduction to Instruments & Air quality testingCheck Schedule
8 hours
Proper procedures for attendant rescue without entrance into the areaCheck Schedule
200 hours
In order to Participate you must have been a member for 3 consecutive years . Oxy-Acetylene, and Oxy-Propane steel cutting, brazing, introduction to arc-welding, includes CWB testing in the final week of the programCheck Schedule
16 hours
Construction math, load calculations, proper hitches, rigging equipment, and Universal hand signalsCheck Schedule
8 hours
Proper starting procedures, Personal protective Equipment, saw maintenance, and operational hazardsCheck Schedule

 

6 hours
Introduction and use of Fire extinguishersCheck Schedule
8 hours – 2-3 days
Experienced Operators Included in CCW Apprentice program (time may be reduced if skill testing is adequate)Check Schedule

 

16 hours – 2-3 days
Experienced operators For new workers in the industry (time may be reduced if skill testing is adequate)Check Schedule
8 hours – 2-3 days
Experienced Operators Included in CCW Apprenticeship Program (time may be reduced if skill testing is adequate)Check Schedule
8 hours – 2-3 days
Experienced Operators Included in CCW Apprenticeship Program (time may be reduced if skill testing is adequate)Check Schedule

 

40 hours
Introduction to Blueprints, lasers, levels, theodolites, and construction mathCheck Schedule
40 hours
Introduction to Basic blueprints, drawings, and cross sectionsCheck Schedule
80 hours – 2 weeks
Layout, hands on forming, pouring of concrete, consolidation, and finishing, grading & compactionCheck Schedule

 

8 hours – 2-3 days
For Experienced Operators, an Introduction to the Regulations and the Equipment for proper operating proceduresCheck Schedule
40 hours – 5 days
Introduction to 3 types of Scaffold used in the industry including proper erecting & dismantlingCheck Schedule
40 hours – 5 days
Scaffold Builder is a Pre-Requisite, Proper procedure for Tending to MasonsCheck Schedule
5 hours
Introduction to regulation and proper operating proceduresCheck Schedule
8 hours
Introduction to rebar tying for slabs and wallsCheck Schedule
40 hours – 5 days
Introduction to job built forms and the PERI form systemCheck Schedule
5 hours
Introduction to the Act & Regulations and proper Trenching applicationsCheck Schedule
8 hours – 2-3 days
For Experienced operators, an introduction to proper operating proceduresCheck Schedule
8 hours
Working at Heights is a pre-requisite for this program. Introduction to the regulation and proper operating proceduresCheck Schedule
5 hours
Proper use, handling and storage of propane cylinders, torches and heatersCheck Schedule
2 days – 16 hours
Introduction to proper use of a sand blasting pod and safety regulations covered for this equipmentCheck Schedule